1. It is recommended that users set up bypass pipelines when conditions permit, in order to ensure the convenience of daily maintenance and periodic calibration of the flow meter.
2. The installation direction of the target flow meter should be the same as the flow direction of the fluid.
3. During installation, avoid strong impact on the instrument, which may cause damage to the instrument or cause serious zero drift.
4, if the installation is vertical or tilt installation, the flow of the fluid is recommended to be from the bottom to the top, and both ends of the instrument installation must be sealed strictly, can not leak.
5, in the installation should pay attention to do not install valves or elbow in the front and rear end of the meter to greatly change the flow of the fluid components, so as not to cause the problem of inaccurate measurement.