Ultrasonic BTU meter

Ultrasonic BTU meter

Ft101 is a wall-mount, clamp- on type ultrasonic flowmeter which use the transfer time technology. Clamp on type ultrasonic flowmeter is easy to install and no need to cut off the pipe, that saves you lots of troubles and cost. At the same time FT101 has our unique calculate software to ensure the high accuracy and low velocity response.
Chat Now

Product Details

FT101 transfer time ultrasonic flow meter

Wall mount, transducers time ultrasonic flow Meter. 

Use our  independent technical TGA calculate Software.

What’s TGA?

  TGA is our independent R&D technical, which based on the well known TDC calculate software. But TGA has higher speedy, higher   accuracy performance on the measure the real time. We use a 400,000 gate array FPGA to satisfied the requirement and make sure the performance of this complicated TGA calculate software


Transmitter(Electronic)

TGA technical greatly improved the rate of sampling. FT101 ultrasonic flow meter rate of sampling is greater than 300 times per second. Compared with other ultrasonic flow meter, it has better bearing performance when face

the bubbles. The maximum tolerable is 5 seconds of continuous air bubbles.

  Increase the single strength. The increase of signal strength is more easy to penetrate for various kinds of scale, rust inside the pipe and inner lining. The maximum tolerable cement inner is 18mm. With the enhanced transducers, the biggest clamp on type transducers we used in field is DN2000mm.


Inquiry